Product brochures
Project focus
Product overview
i-CXW 502 - 1104
The 4-way i-CXW cassette features a brushless synchronous electronic motor with permanent magnets, which is controlled by an inverter. The air flow can be varied continuously thus offering extreme efficiency and silent operation. The i-CXW range is available in 5 sizes for installation in 2 or 4-pipe systems. The 2-pipe version can be equipped with an integrated electrical heater. Thanks to the elegant design of the air diffuser and the wide range of controls for single or multiple connections, the i-CXW cassettes are suitable for all kinds of installations.
Topic overview
Product features
Features- Intake and distribution 4-way grid made from ABS, white colour RAL9003. Manually adjustable air distribution louvers on each side.
- Casing made of galvanized steel with internal thermal insulation in polyethylene foam (class M1) and external anti-condensate lining.
- The fan assembly, which is mounted on anti-vibrating supports, is particularly silent and efficient. The single radial fan is connected to a three phase permanent magnet brushless electronic motor that is controlled by an inverter. The air flow can be varied continuously.
- Coil made of copper tubes with bonded aluminium fins for maximum heat transfer efficiency.
- Control Panel made of an external box with the control electronic card with an easily accessible terminal board.
- Drain pan in high density ABS and built-in condensation drain pump with float switch and wired to the control panel.
- The units can be supplied with on-board i-HB power board to manage groups of units in Master/Slave configuration and for integration in supervision systems with the expansion module Modbus RTU - RS 485.
- The units with 1 battery (2 pipe system) can be supplied with integrated electric heater.
- The units can be equipped with fresh air intake and a remote air diffuser can be connected to the unit.
Produkt-Informationen
Produkt-Informationen- i-CXW 2T - 2-Pipe Unit
- i-CXW 4T - 4-Pipe Unit
- Metal diffuser painted in RAL 9003 white colour, Coanda effect
- Two or three way ON/OFF valves, with thermostatic actuator
- Integrated electric heater (2-pipes units only)
- i-HB power board for units with AC motor and EKW / IKW controls
- Kit RS485 - interface for Building Management System
- Fresh Air renewal connection
- Duct Connection Flange
ATW-EC wall mounted thermostat
Thermostat with set point regulation (temperature indication for ATW only). Mode button (OFF/COOLING/HEATING/AUTO) and fan speed button (Max/Med/Min/AUTO).
Main and additional coil valves ON/OFF control in cooling/heating operation (for 2 or 4 pipes installation). Electric heater control in 2 pipes systems (ATW only).
Remote room air temperature probe in AT-EC (on-board sensor in ATW-EC) and remote water temperature probe.
Proportional control 0-10Vdc of the fan speed.
Digital input configurable as: window contact, economy, heating or cooling remote changeover.
Periodic ventilation set. HOT START function (heating mode only). TOO COOL function (cooling mode only).
Blue LEDs indicates system’s turning-on, mode and fan speed.
230V~ or 24V~ 50-60Hz power supply.
The ATW-EC thermostat cannot be connected in BMS centralized management system.